Configuration Guide 412
Configuring DHCP Service Example for DHCP VLAN Relay
In this example, the DHCP server is demonstrated with T1500G-10PS and the DHCP
relay agent is demonstrated with T1500G-28PCT. This chapter provides configuration
procedures in two ways: using the GUI and using the CLI.
4.3 Using the GUI
Configuring the DHCP Server
1) Choose the menu L3 FEATURES > DHCP Service > DHCP Server > DHCP Server to
load the following page. In the Global Config section, enable DHCP Server globally.
Figure 4-2 Configuring DHCP Server
2) Choose the menu L3 FEATURES > DHCP Service > DHCP Server > Pool Setting and
click
to load the following page. Create a DHCP pool for the clients. Configure
the corresponding parameters as the following picture shows.
Figure 4-3 Configuring DHCP Pool 1 for VLAN 10
Configuring the VLANs on the Relay Agent
3) Choose the menu L2 FEATURES > VLAN > 802.1Q VLAN > VLAN Config and click
to load the following page. Create VLAN 10 and VLAN 20 for the Marketing
To Next Page
Loading...
