Configuration Guide 204
Configuring GVRP Configuration Example
3.3 Using the GUI
GVRP configuration for Switch 3 is the same as Switch 1, and Switch 4 the same as Switch 2.
Other switches share similar configurations.
The following configuration procedures take Switch 1, Switch 2 and Switch 5 as example.
Configurations for Switch 1
1) Choose the menu L2 FEATURES > VLAN > 802.1Q VLAN > VLAN Config and click
to load the following page. Create VLAN 10 and add tagged port 1/0/1 to it.
Click Create.
Figure 3-2 Create VLAN 10
2) Choose the menu L2 FEATURES > VLAN > GVRP to load the following page. Enable
GVRP globally, then click Apply. Select port 1/0/1, set Status as Enable, and set
Registration Mode as Fixed. Keep the values of the timers as default. Click Apply.
To Next Page
Loading...
