TP-Link T1500 Series - 2. DHCP Relay Configuration

Configuring DHCP Service DHCP Relay Configuration
Configuration Guide
399
2
DHCP Relay Configuration
To complete DHCP Relay configuration, follow these steps:
1) Enable DHCP Relay. Configure Option 82 if needed.
2) Specify DHCP server for the Interface or VLAN.
2.1 Using the GUI
2.1.1 Enabling DHCP Relay and Configuring Option 82
Choose the menu L3 FEATURES > DHCP Service > DHCP Relay > DHCP Relay Config to
load the following page.
Figure 2-1 Enable DHCP Relay and Configure Option 82
Follow these steps to enable DHCP Relay and configure Option 82:
1) In the Global Config section, enable DHCP Relay globally and configure the relay hops
and the time threshold. Click Apply.