TP-Link T1500 Series - Configuring MLD Snooping for Ports

Configuring Layer 2 Multicast MLD Snooping Configuration
Configuration Guide
237
Forbidden
Router Ports
Select the ports to forbid them from being router ports in the VLAN.
2) Click Save.
3.1.3 Configuring MLD Snooping for Ports
Choose the menu L2 FEATURES > Multicast > MLD Snooping > Port Config to load the
following page.
Figure 3-3 Configure MLD Snooping for Ports
Follow these steps to configure MLD Snooping for ports:
1) Enable MLD Snooping for the port and enable Fast Leave if there is only one receiver
connected to the port.
MLD Snooping Enable or disable MLD Snooping for the port.
Fast Leave Enable or disable Fast Leave for the port.
Fast Leave can be enabled on a per-port basis or per-VLAN basis. When enabled
on a per-port basis, the switch will remove the port from the corresponding
multicast group of all VLANs before forwarding the done message to the querier.
You should only use Fast Leave for a port when there is a single receiver
connected to the port. For more details about Fast Leave, see
3.1.2 Configuring
MLD Snooping for VLANs
.
LAG Displays the LAG the port belongs to.
2) Click Apply.