Configuring LLDP Appendix: Default Parameters
Configuration Guide
395
7
Appendix: Default Parameters
Default settings of LLDP are listed in the following tables.
Default LLDP Settings
Table 7-1 Default LLDP Settings
Parameter Default Setting
LLDP Disable
LLDP Forward Message Disable
Transmit Interval 30 seconds
Hold Multiplier 4
Transmit Delay 2 seconds
Reinitialization Delay 2 seconds
Notification Interval 5 seconds
Fast Start Repeat Count 3
Table 7-2 Default LLDP Settings on the Port
Parameter Default Setting
Admin Status Tx&Rx
Notification Mode Disable
Included TLVs All
Default LLDP-MED Settings
Table 7-3 Default LLDP-MED Settings
Parameter Default Setting
Fast Start Repeat Count 4
LLDP-MED Status (port) Disable
Included TLVs All
To Next Page
Loading...
