Configuration Guide 646
Configuring IPv4 IMPB Appendix: Default Parameters
6
Appendix: Default Parameters
Default settings of DHCP Snooping are listed in the following table:
Table 6-1 DHCP Snooping
Parameter Default Setting
Global Config
DHCP Snooping Disable
VLAN Config
Status Disable
Port Config
Maximum Entry 512
Default settings of ARP Detection are listed in the following table:
Table 6-2 ARP Detection
Parameter Default Setting
Global Config
ARP Detect Disable
Validate Source MAC Disable
Validate Destination MAC Disable
Validate IP Disable
VLAN Config
Status Disable
Log Status Disable
Port Config
Trust Status Disable
Limit Rate 100 pps
To Next Page
Loading...
