TP-Link T1500 Series - Voice VLAN Configuration; Using the GUI; Configuring OUI Addresses

Configuration Guide 450
Configuring QoS Voice VLAN Configuration
4
Voice VLAN Configuration
To complete the voice VLAN configurations, follow these steps:
1) Create a 802.1Q VLAN
2) Configure OUI addresses
3) Configure Voice VLAN globally
4) Add ports to Voice VLAN
Configuration Guidelines

Before configuring voice VLAN, you need to create a 802.1Q VLAN for voice traffic. For
details about 802.1Q VLAN Configuration, please refer to
Configuring 802.1Q VLAN
.

VLAN 1 is a default VLAN and cannot be configured as the voice VLAN.

Only one VLAN can be set as the voice VLAN on the switch.
4.1 Using the GUI
4.1.1 Configuring OUI Addresses
The OUI address is assigned as a unique identifier by IEEE (Institute of Electrical and
Electronics Engineers) to a device vendor. It is used by the switch to determine whether a
packet is a voice packet.
If the OUI address of your voice device is not in the OUI table, you need to add the OUI
address to the table.
Choose the menu QoS > Voice VLAN > OUI Config to load the following page.