Configuration Guide 619
Configuring IPv4 IMPB IP-MAC Binding Configuration
1) Enter the following information to specify a host.
Host Name Enter the host name for identification.
IP Address Enter the IP address.
MAC Address Enter the MAC address.
VLAN ID Enter the VLAN ID.
2) Select protect type for the entry.
Protect Type Select the protect type for the entry. The entry will be applied to to the specific
feature. The following options are provided:
None: This entry will not be applied to any feature.
ARP Detection: This entry will be applied to the ARP Detection feature.
IP Source Guard: This entry will be applied to the IPv4 Source Guard feature.
Both: This entry will be applied to both of the features.
3) Enter or select the port that is connected to this host.
4) Click Apply.
2.1.2 Binding Entries via ARP Scanning
With ARP Scanning, the switch sends the ARP request packets of the specified IP field to
the hosts. Upon receiving the ARP reply packet, the switch can get the IP address, MAC
address, VLAN ID and the connected port number of the host. You can bind these entries
conveniently.
Note:
Before using this feature, make sure that your network is safe and the hosts are not suffering from
ARP attacks at present; otherwise, you may obtain incorrect IP-MAC Binding entries. If your network is
being attacked, it’s recommended to bind the entries manually.
To Next Page
Loading...
