TP-Link T1500 Series - Configuring the Device Description

Configuration Guide 34
Managing System System Info Configurations
System Location - SHENZHEN
Contact Information - www.tp-link.com
Hardware Version - T1500-28PCT 3.0
Software Version - 3.0.0 Build 20171129 Rel.38400(s)
Bootloader Version - TP-LINK BOOTUTIL(v1.0.0)
Mac Address - 00-0A-EB-13-23-A0
Serial Number -
System Time - 2017-12-12 11:23:32
Running Time - 1 day - 2 hour - 33 min - 42 sec
2.2.2 Configuring the Device Description
Follow these steps to configure the device description:
Step 1 configure
Enter global configuration mode.
Step 2 hostname [
hostname
]
Specify the system name of the switch.
hostname
: Enter the device name. The length of the name ranges from 1 to 32 characters. By
default, it is the model name of the switch.
Step 3 location [
location
]
Specify the system location of the switch.
location
: Enter the device location. It should consist of no more than 32 characters. By default,
it is “SHENZHEN”.
Step 4 contact-info [
contact-info
]
Specify the system contact Information.
contact-info
: Enter the contact information. It should consist of no more than 32 characters. By
default, it is “www.tp-link.com”.
Step 5 show system-info
Verify the system information including system Description, Device Name, Device Location,
System Contact, Hardware Version, Firmware Version, System Time, Run Time and so on.
Step 6 end
Return to privileged EXEC mode.
Step 7 copy running-config startup-config
Save the settings in the configuration file.