Configuration Guide 492
Configuring Access Security Access Security Configurations
2) In the Entry Table section, click to add an Access Control entry.
When the IP-based mode is selected, the following window will pop up.
Figure 2-2 Configuring Access Control Entry-IP Based
Access
Interface
Select the interface to control the methods for users’ accessing.
SNMP: A function to manage the network devices via NMS.
Telnet: A connection type for users to remote login.
SSH: A connection type based on SSH protocol.
HTTP: A connection type based on HTTP protocol.
HTTPS: A connection type based on SSL protocol.
Ping: A communication protocol to test the connection of the network.
IP Address/
Mask
Enter the IP address and mask to specify an IP range. Only the users within this IP
range can access the switch.
When the MAC-based mode is selected, the following window will pop up.
Figure 2-3 Configuring Access Control Entry-MAC Based
To Next Page
Loading...
