TP-Link T1500 Series - Page 53

Managing System System Info Configurations
Configuration Guide
31
Management
VLAN ID
Displays the Management VLAN ID. Only the computers in the management
VLAN can access the management interface of the switch. By default, VLAN 1
owning all the ports is the management VLAN and you can access the switch via
any port
.
IPv6 Enable Enable the IPv6 feature of the management interface.
Link-local
Address Mode
Select the link-local address configuration mode.
Manual: With this option selected, you can assign a link-local address manually.
Auto: With this option selected, the switch generates a link-local address
automatically.
Link-local
Address
Enter a link-local address if you choose “Manual” as the Link-Local Address
Mode.
Status Displays the status of the link-local address. An IPv6 address cannot be used
before pass the DAD (Duplicate Address Detection), which is used to detect the
address conflicts. In the DAD process, the IPv6 address may in three different
status:
Normal: Indicates that the link-local address passes the DAD and can be used
normally.
Try: Indicates that the link-local address is in the progress of DAD and cannot be
used right now.
Repeat: Indicates that the link-local address is duplicated, this address is already
used by another node and cannot be used by the interface.
2) Configure IPv6 global address of the interface via following three ways:
Via RA Message:
Enable global
address auto
configuration via
RA message
With this option enabled, the interface automatically generates a global address
and other information according to the address prefix and other configuration
parameters from the received RA (Router Advertisement) message.
Via DHCPv6 Server:
Enable global
address auto
configuration via
DHCPv6 Server
With this option enabled, the switch will try to obtain the global address from the
DHCPv6 Server.
Manually:
In the Global Address Cong section, click
to manually assign an IPv6 global
address to the interface.