TP-Link T1500 Series - Page 375

Configuring Spanning Tree Configuration Example for MSTP
Configuration Guide
353
Switch(config)#spanning-tree
Switch(config)#end
Switch#copy running-config startup-config

Configurations for Switch C
1) Enable the spanning tree function on port 1/0/1 and port 1/0/2.
Switch#configure
Switch(config)#interface range gigabitEthernet 1/0/1-2
Switch(config-if-range)#spanning-tree
Switch(config-if-range)#exit
2) Configure the region name as 1, the revision number as 100; map VLAN101-VLAN103
to instance 1; map VLAN104-VLAN106 to instance 2; configure the priority of Switch C
in instance 2 as 0 to set it as the root bridge in instance 2:
Switch(config)#spanning-tree mst configuration
Switch(config-mst)#name 1
Switch(config-mst)#revision 100
Switch(config-mst)#instance 1 vlan 101-103
Switch(config-mst)#instance 2 vlan 104-106
Switch(config-mst)#exit
Switch(config)#spanning-tree mst instance 2 priority 0
3) Configure the spanning tree mode as MSTP, then enable spanning tree function
globally.
Switch(config)#spanning-tree mode mstp
Switch(config)#spanning-tree
Switch(config)#end
Switch#copy running-config startup-config
Verify the Configurations

Switch A
Verify the configurations of Switch A in instance 1:
Switch(config)#show spanning-tree mst instance 1
MST-Instance 1
Root Bridge