TP-Link T1500 Series - Page 692

Configuration Guide 670
Configuring IPv6 IMPB IPv6 Source Guard Configuration
Step 3 ipv6 verify source { sipv6+mac | sipv6 }
Enable IPv6 Source Guard for IPv6 packets.
sipv6+mac
:
Only the packet with its source IP address, source MAC address and port
number matching the IPv6-MAC binding rules can be processed, otherwise the packet will
be discarded.
Step 4 show ipv6 verify source [ interface { fastEthernet
port
| gigabitEthernet
port
| ten-
gigabitEthernet
port
| port-channel
port-channel-id
} ]
Verify the IP Source Guard configuration for IPv6 packets.
Step 5 end
Return to privileged EXEC mode.
Step 6 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to enable IPv6 Source Guard on port 1/0/1:
Switch#configure
Switch(config)#interface gigabitEthernet 1/0/1
Switch(config-if)#ipv6 verify source sipv6+mac
Switch(config-if)#show ipv6 verify source interface gigabitEthernet 1/0/1
Port Security-Type LAG
---- ------------- ----
Gi1/0/1 SIPv6+MAC N/A
Switch(config-if)#end
Switch#copy running-config startup-config