TP-Link T1500 Series - Page 790

Configuration Guide 768
Configuring SNMP & RMON Notification Configurations
Step 3 end
Return to privileged EXEC mode.
Step 4 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to configure the switch to enable IP-Change trap:
Switch#configure
Switch(config)#snmp-server traps ip change
Switch(config)#end
Switch#copy running-config startup-config

Enabling the SNMP PoE Traps Globally
Note:
Only T1500G-10PS, T1500G-10MPS and T1500-28PCT support PoE traps.
Step 1 configure
Enter global configuration mode.
Step 2 snmp-server traps power [over-max-pwr-budget | port-pwr-change | port-pwr-deny | port-
pwr-over-30w | port-pwr-overload | port-short-circuit | thermal-shutdown ]
Enable the PoE traps. The command without parameter enables all PoE traps. All PoE traps
are disabled by default.
over-max-pwr-budget: Triggered when the total power required by the connected PDs
exceeds the maximum power the PoE switch can supply.
port-pwr-change: Triggered when the total power required by the connected PDs exceeds
the maximum power the PoE switch can supply.
port-pwr-deny: Triggered when the switch powers off PDs on low-priority PoE ports. When
the total power required by the connected PDs exceeds the system power limit, the switch
will power off PDs on low-priority PoE ports to ensure stable running of the other PDs.
port-pwr-over-30w: Triggered when the power required by the connected PD exceeds 30
watts.
port-pwr-overload: Triggered when the power required by the connected PD exceeds the
maximum power the port can supply.
port-short-circuit: Triggered when a short circuit is detected on a port.
thermal-shutdown: Triggered when the PSE chip overheats. The switch will stop supplying
power in this case.
Step 3 end
Return to privileged EXEC mode.