BMTX-SVU01B-EN 9
Chapter 2
Using the Daily Operations
Tu t o ri a l
The daily operations tutorial Focus on Your System can be used in two
ways. You can use the tutorial as a self-paced training course to get train-
ing on basic Tracer Summit operations. Or you can access the tutorial
from the Tracer Summit software to get training on a specific task before
performing it within Tracer Summit.
This chapter is divided into two sections:
• Using the Tutorial within Tracer Summit Software
• Using the Tutorial as a Stand-alone Training Course
Using the Tutorial within Tracer Summit
Software
To use the Tracer Summit Daily Operations Tutorial, you must first run
the tutorial installation program on your PC. (Refer to the Tracer Summit
Hardware and Software Installation guide.) After you have installed the
program, tutorial buttons appear on the following:
• Schedule window
• Overrides dialog box
• Event Log window
• Chiller Plant Status screen
• Reports window
• Backup dialog box
• Restore Site dialog box
Figure 6 on page 10 shows an example of a tutorial button in Tracer Sum-
mit. The tutorial buttons give you access to specific training modules on
the tutorial CD-ROM. To access the training modules, you must have the
Daily Operations Tutorial CD-ROM in the CD-ROM drive of your PC.
To Next Page
Loading...
