Using the Simplified Override Dialog Box
BMTX-SVU01B-EN 65
Overriding a Multi-State Analog Output
1. Open the Simplified Override dialog as described in “Accessing the
Simplified Override Dialog box” on page 60. The Override dialog box
displays (see Figure 57).
Figure 57. Analog Output (Multi-state) Override Dialog Box
2. Click on the Manual option in the Auto/Manual knob. This enables
the multi-state slider bar and the Apply button.
Note:
The analog output (AOP) object must be setup in the editor as a
multistate object for this view.
Note:
Click on the More control button at the bottom of the dialog box
to display the Priority Arrays box. To perform an override, your
default control priority level must be higher than priority level
listed in the box. If not, refer to “Using the Advanced Systems
Override” on page 72.
To Next Page
Loading...
