Displaying and Changing Status Information
64 BMTX-SVU01B-EN
Overriding an Analog Output or Analog Value in a Non-
Trane BACnet Device
1. Open the Simplified Override dialog as described in “Overriding a
Binary Output or a Lighting Value” on page 67. The Override dialog
box displays (see Figure 56).
Figure 56. Non-Trane Analog Output Override Dialog Box
2. Click in the text field to enter a new value.
3. Click the Apply button to apply the override and view the results, or
click OK to apply the changes and close the dialog box.
Note:
Click on the More control button at the bottom of the dialog box
to display the Priority Arrays box. To perform an override, your
default control priority level must be higher than priority level
listed in the box. If not, refer to “Using the Advanced Systems
Override” on page 72.
To Next Page
Loading...
