Running Reports
144 BMTX-SVU01B-EN
Running a Standard Live Report
In Tracer Summit some reports are linked to graphics. A graphic may
have one or more associated reports, or have no associated reports. There
is another type of standard live report, the site report, described in “Run-
ning a Standard Live Site Report” on page 148
The steps for running a standard live report vary depending upon
whether you have the graphic displayed for which you want to run a
report and whether there are reports associated with the graphic.
Refer to the next section “Running a Standard Live Report from a
Graphic with Associated Reports” if you currently have the graphic dis-
played for which you want to run a report.
Refer to “Running a Standard Live Report in Other Situations” on
page 145 if the Report Viewer is already open and you want to run a
report for another graphic, or if the current graphic has no associated
reports. Also refer to this section if the current graphic is not the one for
which you want to run the report.
Running a Standard Live Report from a Graphic
with Associated Reports
1. Display the graphic for the object, application or piece of equipment
for which you want to run the report.
2. Click the Reports button on the task bar (see Figure 131).
Figure 131. Reports Button in the Task Bar
If there is only one report associated with the graphic, the Standard
Live Report for that graphic displays in the Report Viewer (see
Figure 132 on page 145). If there is more than one report associated
with the graphic, proceed to step 3.
Step 2
To Next Page
Loading...
