Trimble SCS900 User Manual

4 Measurement screen
Measure modes
The Measure mode controls a number of functions for the GPS receiver and total station. There are
multiple modes available, which you can switch between by tapping the Measure Mode icon on the
left side of the status bar or in the Trimble icon menu in the Measure Mode option.
GPS measure mode
GPS measure
mode
Name Description
Standing Walk to a point and then take a single measurement.
Walking Walk the site and continuously take measurements. Points
are stored based on a setting for horizontal distance and
elevation change, which can be set by tapping the Measure
mode icon either in the status bar or in the Trimble icon
menu.
Vehicle Drive the site in a vehicle. Points are stored based on a setting
for horizontal distance and elevation change, which can be set
by tapping the Measure mode icon either in the status bar or
in the Trimble icon menu.
Static Measure a point for a longer period and to achieve a greater
accuracy.
Total Station measure mode
Total Station
measure mode
Name Description
Standing Walk to a point and then take a single measurement.
Walking Walk the site and take continuously measurements. Points
are stored based on a setting for horizontal distance and
elevation change, which can be set by tapping the Measure
mode icon either in the status bar or in the Trimble icon
menu.
Vehicle Drive the site in a vehicle. Points are stored based on a setting
for horizontal distance and elevation change, which can be
set by tapping the Measure mode icon either in the status
bar or in the Trimble icon menu.
Averaging Measure a point in multiple faces/rounds.
DR Measure a point using a DR reflectorless total station.
Trimble SCS900 Site Controller Software User Guide 25

Trimble SCS900 Specifications

General

Brand	Trimble
Model	SCS900
Category	Controller
Language	English