10 Measuring with a Total Station
In this chapter:
n
Connecting to a total station
n
Leveling the total station
n
Establishing the station
n
Arbitrary location
n
Setting up on a known point
n
Reading station setup data from the total
station
n
Completing a station establishment where
the height of the setup point has not been
determined
n
Working with a mechanical total station
To perform measurement or stakeout tasks, you
need the SCS900 site controller software running
on a controller that is connected to a positioning
device. This chapter explains how to set up and
use SPS Series total stations with the SCS900
software.
Trimble SCS900 Site Controller Software User Guide 92
10
CHAPTER
To Next Page
Loading...
Need help?
General
