Trio Motion Coordinator MC206 User Manual

8-96 Trio BASIC Commands
System Parameters and Commands
Trio Motion Technology
When using the Memory Stick users should refer to the overview in the MC206
Hardware Overview for a complete description of the Memory Stick
functionality.
ERROR_AXIS
Type:
System Parameter (Read Only)
Description:
Returns the number of the axis which caused the enable WDOG relay to open when a
following error exceeded its limit.
Example:
>>? ERROR_AXIS
ETHERNET
Type:
System Command
Syntax:
ETHERNET(read/write, slot number, function [,data])
Description:
The command ETHERNET is used to read and set certain functions of the Ethernet
daughter board. The ETHERNET command should be entered on the command line
with Motion Perfect in “disconnnected” mode via the serial port 0. This command
is available on MC206 and MC224 only.
Parameters:
read / write:
Specifies the required action.
0 = Read
1 = Write to Flash EPROM
2 = Write to RAM
slot number:
The daughter board slot where the Ethernet port has been
installed. On the MC206 this is always slot 0.

Trio Motion Coordinator MC206 Specifications

General

Brand	Trio
Model	Motion Coordinator MC206
Category	Controller
Language	English