CFM-BL10Pro General instruction manual
20 / 87
3. Program
CFM-BL10Pro can register maximum 99 combinations of terminals, wires and
applicators as Program. In that Program, appropriate settings and tolerance can be
saved as a data base.
If you produce the same item as previous, only select its program from Program list.
Then, CFM automatically changes its settings to the recorded appropriate conditions.
3.1. Program
From System settings, select whether you use Program or not in which the
combination of terminals, wires and applicators can be saved.
When Program is disable, the condition for capturing force curve and tolerance you
set are used for all produced items as common settings. The reference force curve is
registered every time when production is started.
When Program is enabled, Program is selected from Program List which is shown by
pressing Program icon. The reference force curve is registered every time when
productions is started.
3.2. No program
When Program is enabled, “No program” is arranged in the No.0 of the Program List.
It can be used as a shared program when you produce an item which is not
registered in the Program List. And when Program is not enabled, the settings of “No
Program” is used as common settings. The ID of terminals, wires, applicators and so
on cannot be registered in “No Program.”
3.3. Cycle crimp function
When Program is enabled, Cycle crimp function which is effective for crimping
multiple wires is available in each program except for No program. With this function,
CFM registers reference force curves for each multiple wire and flat cable and
performs judgements. Use this function when you have to crimp one composite wire
in the right order in which has several different specifications of wires. Maximum 32
species of reference force curve can be registered in every program.
To Next Page
Loading...
