CFM-BL10Pro General instruction manual
61 / 87
Changing this tolerance values depending on a certain program can
be affected on the other program in which the same tolerance
number is used. And this change may be affected on the calculation
of the Auto tolerance. Therefore, do not change the tolerance table
except for the case of special needs.
All tolerance values can be initialized by clicking “Default value Tolerance”.
6.3.4. Other settings
The brightness of the main unit LCD can be
adjusted with the Slide bar.
This function is for the Preload which is
needed when installing the FTW and FTC
sensor inside the base plate.
As for the Sensor preload, refer to 7.1.3 FTW
Sensor preload. The preload is not required
for the PSS sensor.
To Next Page
Loading...
