CFM-BL10Pro General instruction manual
23 / 87
area in the range from 0: Judgement = OFF to ±99.0 and in TD in the range from 0.1
to 300.
If the tolerance is too big, defective samples cannot be detected. Therefore,
definitely carry out detection trials and check if the current tolerance is
appropriate for producing item after the tolerance is changed.
Tolerance can be freely changed. This mode is used when it is
difficult to judge force curves with an auto tolerance and
tolerance number and you would like to set a special tolerance
aiming at defective sample you would like to detect.
To Next Page
Loading...
