CFM-BL10Pro General instruction manual
5 / 87
7.1.2. FTW Sensor .................................................................................................... 71
7.1.3. FTW Sensor preload ...................................................................................... 72
7.2. Connection and wiring ........................................................................................... 73
7.2.1. Main unit connection ....................................................................................... 73
7.2.2. Machine connection (STOP signal) ................................................................ 74
7.2.3. Machine connection (Eject signal) .................................................................. 75
7.2.4. External trigger switch installation (Option) .................................................... 75
7.2.5. Trigger signal from PLC/Sequencer ............................................................... 76
7.2.6. External Program selection ............................................................................ 76
7.2.7. Time chart ....................................................................................................... 78
8. Trouble shooting ............................................................................................................ 79
8.1. CFM cannot detect critical defective samples. ...................................................... 79
8.2. CFM cannot detect subtle defective samples. ....................................................... 80
8.3. CFM cannot detect defective samples of large-scale wires. ................................. 81
8.4. Force curve of thin wire such as AWG30 and more is not stable. ......................... 81
8.5. False judgement usually occurs, which makes the crimping machine stop
frequently. .......................................................................................................................... 82
8.6. CFM-BL10Pro does not show a force curve after crimping .................................. 84
8.7. The LCD screen is not on even if the power switch is already turned on ............. 85
8.8. Unable to connect to PC ........................................................................................ 85
8.9. Electrical noise gets in and causes the force curves to become abnormal. ......... 85
8.10. CFM fails to detect serious defects such as crimps without terminal / wire. ..... 85
9. Warranty ........................................................................................................................ 86
To Next Page
Loading...
