69
▪ Secondary
With this selection the meter displays the value injected into the back of the DME
system.
o Select Channels:
This panel provides the following controls:
▪ Channel Input Field
This field allows an input number to be entered.
▪ Select Button
This button displays a list of available analog channel descriptions to select from.
Multiple channels can be selected by using Ctrl+Left-click or Shift+Left-click.
o Browse Channels:
This panel provides the following controls:
▪ Previous Button
This button decrements the analog channel number displayed in the Select
Channels panel.
▪ Next Button
This button increments the analog channel number displayed in the Select
Channels panel.
o Total Cycles:
This panel provides the following controls:
▪ Cycle Input Field
This field allows the number of waveform cycles to be entered.
▪ Apply Button
This button applies the value entered in the entry field.
o Events:
This panel provides the following controls:
▪ Test… Button
This button displays the EventTest Confirmation window and is used to initiate the
self-test routine. This function is intended to be exercised at any time for
verification of all digital inputs.
To Next Page