VEMAG HP12E - Page 107

HP10E / HP12E / HP15E / HP20E - Dairy design 6. Graphical control
6-69© VEMAG 2013
Number Message Cause Remedy
628 Jumper A-G is misplaced
in the remote control
connector!
The jumper A-G is not permitted in
this operating mode.
Change the operating mode or
insert the corresponding remote
control cable.
629 Vacuum protection imple-
mented
The specied product volume was
produced before it could get to the
lling system vacuum area
-
630 Vacuum is deactivated! Vacuum control is set to „No
vacuum“ (= -1). This warning is
supposed to prevent this setting
from being unintentionally used for
production.
-
700 Remote access logout User or application logged out of
remote access.
--
701 Remote access Remote access login failed, not
permitted.
--
702 Remote access logout Remote access logout after time-
out of 3 seconds.
--
703 Remote access Remote access login failed, incor-
rect password.
--
704 Remote access login Remote access login - read only --
705 Remote access login Remote access login - with read/
write access
--
706 Remote access Remote access - send message --
707 Remote access Remote access - set value --
802 Correction greater than
setpoint
The weight correction entered
is too high.
Enter a smaller value for the
weight correction.
804 Weight limits speed The value range for input depends
on another parameter and vice
versa.
-
805 Clip delay limits pause The value range for input depends
on another parameter and vice
versa.
-
806 Knife time/offset limits
pause
The value range for input depends
on another parameter and vice
versa.
-
807 Twist delay limits pause The value range for input depends
on another parameter and vice
versa.
-
808 Speed/twist limits pause The value range for input depends
on another parameter and vice
versa.
-
809 Preclip/speed limits pause The value range for input depends
on another parameter and vice
versa.
-
810 Knife time/offset limits
pause
The value range for input depends
on another parameter and vice
versa.
-
811 Weight/speed limits twist
delay
The value range for input depends
on another parameter and vice
versa.
-
812 Weight/speed limits
preclip
The value range for input depends
on another parameter and vice
versa.
-