VEMAG HP12E - Page 113

HP10E / HP12E / HP15E / HP20E - Dairy design 6. Graphical control
6-75© VEMAG 2013
Number Message Cause Remedy
20202 Link point length (lling
pause too short
- -
20203 1st link point length (lling
pause too short)
- -
20204 Link point stretch (lling
speed too high)
- -
20205 Link point stretch (lling
pause too short)
- -
20206 No cut (lling speed too
high)
- -
20207 Check link point sensor - -
20208 Sausage length! - -
20209 Magazine box empty Magazine box is empty -
20210 Check loading edge
sensor!
Loading edge sensor is faulty or
dirty
-
20211 Check magazine box
sensor!
Magazine box sensor is faulty or
dirty
-
20212 Check load gripper sen-
sor!
Load tongs sensor is faulty or dirty -
20213 Casing application failed Casing feed could not apply the
casing
-
20214 Stop by pressing the key
twice — casing left in the
casing brake
Portion cancelled due to the key
being pressed twice
-
20215 Stop due to split casings
— casing left in the casing
brake
Portion cancelled due to split
casings
-
20216 Gripper has more than
one casing
The tongs were loaded with more
than one casing
-
20217 Stop due to ller — casing
left in the casing brake
After stopping due to ller, the
casing is still in the brake
-
20218 Check magazine feed!
/ Check magazine box
sensor!
Magazine feed incorrectly tted or
magazine box sensor is defective
or dirty
-
20219 Check swivel position
sensor!
Sensor is defective or incorrectly
tted
-
20220 Check centring mandrel
sensor!
Sensor is defective or incorrectly
tted
-
20221 Stop due to external
button — casing left in the
casing brake
Stop button/limit switch on the
hanging machine was activated
-
20222 Linking head drive refe-
rencing failed
Drive could not be referenced in
the specied time
-
20223 Casing feed drive referen-
cing failed
Drive could not be referenced in
the specied time
-
20224 Magazine feed drive refe-
rencing failed
Drive could not be referenced in
the specied time
-