HP10E / HP12E / HP15E / HP20E - Dairy design6. Graphical control
6-74 © VEMAG 2013
Number Message Cause Remedy
20006 Safety cover open (casing
pusher)
Casing pusher safety cover is
open
-
20007 Safety cover open Casing magazine safety cover is
open
-
20008 Fallen below voltage of
internal drives (48 V)
Power supply for casing magazine
drives has dropped
-
20009 Safety cover open (belts) Dividing belts safety cover is open -
20010 Filler communication error Error on the internal CAN bus
20011 Fallen below the casing
applier drive voltage
Casing applier drive power supply
has dropped
-
20013 Check casing magazine
sensor
The sensor that checks if the
magazine box is folded down does
not switch.
-
20014 Check dividing belts
sensor
Sensor does not switch or there
are no belts assembled
-
20015 Communication error for
drives
Error on the internal CAN bus -
20016 Blade box opened Blade box FSL 210 is open
20017 Upper belt guide missing
20018 Lower belt guide missing
20019 Safety cover open Safety cover open
20100 Linking drive not ready - -
20101 Belt drive 1 not ready - -
20102 Belt drive 2 not ready - -
20103 Blade drive not ready - -
20104 Adjustable drive for belt 1
not ready
- -
20105 Adjustable drive for belt 2
not ready
- -
20106 Linking head drive not
ready
- -
20107 Casing pusher drive not
ready
- -
20108 Magazine feed drive not
ready
- -
20109 Gripper swivel drive not
ready
- -
20110 Casing applier drive not
ready
- -
20200 Portion length (lling
speed too high)
- -
20201 1st portion length (lling
speed too high)
- -
To Next Page
Loading...
