HP10E / HP12E / HP15E / HP20E - Dairy design 6. Graphical control
6-77© VEMAG 2013
Number Message Cause Remedy
50203 No hook detected
50204 Additional hooks not pos-
sible — group loading
Additional hooks > 0, but no full
load detected.
Set additional hooks to 0 or
change loading. Check the sensor
position if necessary.
50205 Hanging speed exceeded
50206 Hanging speed exceeded
50207 Hanging speed exceeded
50208 Grouping Groups are not of equal size, or
distances between the hooks
within the group are not the same,
or distances between groups of
hooks are not the same.
Ignore the message during reload-
ing. Check the sensor position if
the hooks appear to be placed cor-
rectly after the sensor passes.
50901 External drive 1 not found The PC could not nd the rst
drive controller of attachment 2 on
the CAN bus.
Check the power supply of the
rst drive controller and that the
external CAN bus has been wired
correctly (connector + socket).
50902 External drive 2 not found The PC could not nd the second
drive controller of attachment 2 on
the CAN bus.
Check the power supply of the
second drive controller and check
that the external CAN bus has
been wired correctly (connector +
socket).
50903 External drive 3 not found The PC could not nd the third
drive controller of attachment 2 on
the CAN bus.
Check the power supply of the
third drive controller and check
that the external CAN bus has
been wired correctly (connector +
socket).
50907 External drive 1 commu-
nication
CAN bus communication to the
rst drive controller of attachment
2 was interrupted.
Check that the CAN bus has been
wired correctly.
50908 External drive 2 commu-
nication
CAN bus communication to the
second drive controller of attach-
ment 2 was interrupted.
Check that the CAN bus has been
wired correctly.
50909 External drive 3 commu-
nication
CAN bus communication to the
third drive controller of attachment
2 was interrupted.
Check that the CAN bus has been
wired correctly.
50916 External drive 1 inhibit The rst drive of attachment 2 is
not released.
Check the voltage on terminal 31.
50917 Release of external drive
2 is missing
The second drive of attachment 2
is not released.
Check the voltage on terminal 31.
50918 Release of external drive
3 is missing
The third drive of attachment 2 is
not released.
Check the voltage on terminal 31.
50919 External drive 1 applica-
tion error
There is a communication error
between the application module
of attachment 2 and A1 (PC). This
error occurs in combination with
other error numbers.
Make a note of the numbers of all
errors displayed before this error
and contact VEMAG Customer
Service.
50920 External drive 2 applica-
tion error
There is a communication error
between the application module
of attachment 2 and A1 (PC). This
error occurs in combination with
other error numbers.
Make a note of the numbers of all
errors displayed before this error
and contact VEMAG Customer
Service.
To Next Page
Loading...
