VEMAG HP12E - Page 116

HP10E / HP12E / HP15E / HP20E - Dairy design6. Graphical control
6-78 © VEMAG 2013
Number Message Cause Remedy
50921 External drive 3 applica-
tion error
There is a communication error
between the application module
of attachment 2 and A1 (PC). This
error occurs in combination with
other error numbers.
Make a note of the numbers of all
errors displayed before this error
and contact VEMAG Customer
Service.
50922 External drive 1 manual The rst drive of attachment 2 is
operated manually.
Release manual drive button.
50923 External drive 2 emer-
gency operation
The second drive of attachment 2
is operated manually.
Release manual drive button.
50924 External drive 3 emer-
gency operation
The third drive of attachment 2 is
operated manually.
Release manual drive button.
50925 External drive 2 timeout The reference movement of the
second drive took too long.
Check the reference sensor and
the application module. If there is
no error, contact VEMAG Cus-
tomer Service.
50929 External drive 4 not found The PC could not nd the fourth
drive controller of attachment 2 on
the CAN bus.
Check the power supply of the
fourth drive controller FU4 and
check that the external CAN bus
has been wired correctly (connec-
tor + socket).
50931 External drive 4 commu-
nication
CAN bus communication to the
fourth drive controller of attach-
ment 2 was interrupted.
Check that the CAN bus has been
wired correctly.
50932 External drive 4 timeout The reference movement of the
fourth drive took too long.
Check the reference sensor and
the application module. If there is
no error, contact VEMAG Cus-
tomer Service.
50933 Release of external drive
4 is missing
The fourth drive of attachment 2 is
not released.
Check the voltage on FU4.
50934 External drive 4 applica-
tion error
There is a communication error
between the application module
of attachment 2 and A1 (PC). This
error occurs in combination with
other error numbers. Only with
blade drive.
Make a note of the numbers of all
errors displayed before this error
and contact VEMAG Customer
Service.
50935 External drive 4 emer-
gency operation
The fourth drive of attachment 2 is
operated manually.
Release manual drive button.
50938 External drive 1 timeout The reference movement of the
rst drive took too long.
Check the reference sensor and
the application module. If there is
no error, contact VEMAG Cus-
tomer Service.
50939 External drive 3 timeout The reference movement of the
third drive took too long.
Check the reference sensor and
the application module. If there is
no error, contact VEMAG Cus-
tomer Service.
50949 Drive command failed A command was not accepted/
processed by the drive.
Note all details of the scenario and
notify VEMAG Customer Service.
51000 -
79999
External drive of attach-
ment 2 (e.g. hanging
machine)
There is an error in the external
drive controller.
Make a note of the error number
and contact VEMAG Customer
Service.