HP10E / HP12E / HP15E / HP20E - Dairy design7. Cleaning
7-4 © VEMAG 2013
• Pull the double screw housing right out of the feed cylinder by hand,
holding the housing steady with the other hand.
Fig. 7-6
Removing the double
screw housing
• Then check the rear seal in the feed cylinder for traces of oil.
• The double screw housing can be washed either manually, in a clea-
ning tank or a dishwasher.
• After cleaning, the double screw housing should be inspected for any
residual product. Following this, it may be sanitized manually or me-
chanically with an EPA accepted sanitizing agent.
To Next Page
Loading...
