4-20 Videojet DataFlex 6530 Service Manual - Rev AA
Installation
Job Updated Queue Is Not Full The maximum permitted number of jobs in the queue
has not been reached
Job Updated Queue Is Not High The number of jobs in the queue is not high
Job Updated Queue Is Not Low The number of jobs in the queue is not low
Labeller May Feed Labels
Labeller May Not Feed Labels
Low Ribbon Is Active The ribbon is low
Low Ribbon Is Not Active The ribbon is not low
Low Speed Pack
Multi Print Job Is Active The multi printing job is in progress
Multi Print Job Not Active The multi printing job is not in progress
New Job Allocation Received A new job allocation message has been received by the
printer
New Job Allocation Rendered A new job allocation message has been rendered by the
printer
Not Used The output has no function
Print Cycle Completes The printer can now start a new print (motors and
ribbon are now stationary)
Print Cycle Starts Print signal has been received and any registration
delay has expired
Print Failed A request to print was not successfully completed.
Possible causes are:
• Aborted print
• No allocation available but print signal received
• No print job is selected but a print signal received
Print Signal Ignored The print signal has been ignored by the printer. A
print signal was received whilst a registration delay
was being counted. The printer can be printing and
counting down the next registration delay from a new
print signal (that is processing two print signals
simultaneously) but one of the print signal events must
be in the printing phase whilst the other is in the
registration phase. Two print signals cannot be in the
same phase of printing or registration
Printer Enters Fault A fault condition has occurred
Printer Enters Warning A warning condition has occurred
Printer Finishes Printing The printer has stopped physically printing onto the
product
Options Description
Table 4-3: External Output Options (Continued)
To Next Page
Loading...
