VIDEOJET DataFlex 6530 - Page 86

8-6 Videojet DataFlex 6530 Service Manual - Rev AA
Troubleshooting
E1210 Invalid Job File
- EAN barcode
out of
specification
The Job file is invalid and needs to be corrected using 
CLARiSOFT. An EAN128 barcode field in the Job file contains
an application identifier that requires a check digit, but this
check digit was either missing or invalid. Use CLARiSOFT to
check and correct the EAN128 barcode fields in the Job file.
Then, download the corrected file.
Press the Clear button, to clear this fault message.
E1211 Invalid Job File
- EAN barcode
out of
specification
The Job file is invalid and needs to be corrected using 
CLARiSOFT An EAN128 barcode could not be rendered at a
size of 165 mm or less which is the maximum length for this
type of barcode. Use CLARiSOFT to check and correct the
EAN128 barcode fields in the Job file. Then, download the 
corrected file.
Press the Clear button, to clear this fault message.
E1212 Invalid Job File
- barcode
length
incorrect
The Job file is invalid and needs to be corrected using 
CLARiSOFT. A barcode field in the Job file does not have the
expected number of characters. Use CLARiSOFT to check and
correct the barcode fields in the Job file. Then, download the
corrected file.
Press the Clear button, to clear this fault message.
E1213 Invalid Job File
- barcode out of
limits
The Job file is invalid and needs to be corrected using 
CLARiSOFT. A barcode field in the Job file overruns the edge
of the image and it is not possible to extend the image area to
accommodate the barcode Use CLARiSOFT to check and 
correct the barcode fields in the Job file. Then, download the
corrected file.
Press the Clear button, to clear this fault message.
E1214 Invalid Job File
- Invalid
Checksum
Data
The Job file is invalid and needs to be corrected using 
CLARiSOFT. A field in the Job file uses a checksum (e.g. an
EAN13 barcode with a price verifier digit) but the data 
supplied to calculate the checksum were not valid. Use
CLARiSOFT to check and correct fields using checksums in
the Job file. Then, download the corrected file.
Press the Clear button, to clear this fault message.
E1215 Invalid Job File
- invalid
barcode height
The Job file is invalid and needs to be corrected using 
CLARiSOFT. The height supplied for a barcode in the Job file
is smaller than the minimum allowed by the barcode 
specification. Use CLARiSOFT to check and correct the 
barcode fields in the Job file. Then, download the corrected
file.
Press the Clear button, to clear this fault message.
E1216 Invalid Job File
- Barcode

Symbology
Not Installed
The Job file contains a barcode symbology that is not installed
in this printer. Use CLARiSOFT to remove the barcode from
the Job file. Then, download the corrected file to the printer.
Press the Clear button, to clear this fault message.
Error 
Reference
Name Remedial Action
Table 8-1: Faults and Warnings (Continued)