VIDEOJET DataFlex 6530 - Page 96

8-16 Videojet DataFlex 6530 Service Manual - Rev AA
Troubleshooting
E3232 iAssure File
Transfer 
Failure
Transfer of iAssure calibration files has failed.
Press the Detail button for maintenance assistance.
The transfer of calibration files to disk has failed. Press the
Clear button to clear this warning.
E3233 iAssure Full
Calibration
Required
Could not find valid configuration files for iAssure. Please
remove cassette and carry out a full iAssure calibration.
Press the Detail button for maintenance assistance.
iAssure calibration files have not yet been generated, please
carry out an iAssure calibration by press the Calibrate button.
E3234 Print Cycle
Error
A critical print cycle error has occurred.
Please contact your local service representative for further 
information.
Press the Clear button to attempt to resume printing.
The print engine has encounted a critical error. Please check
for any obvious issues or damage in the printer.
Press the Clear button to attempt to resume printing.
E3235 Printer Busy The printer failed to print after the last print signal due to
other interactions with the machine.
This is usually caused by parameter changes being made
whilst the printer is Running and printing.
Press the Clear button to resume printing.
The printer has detected that it failed to print on the last print
signal. Please check that any external interactions with the
parameter system are not excessive.
Press the Clear button to resume printing.
E3236 Printhead 
Carriage 
Position Error
The printhead carriage has failed to return to its correct 
position.
Switch the power off and remove the cassette. Check that the
printhead carriage movement is free from obstruction and
ensure that its drive belt is not loose.
Refit the cassette and switch the power on.
If the problem persists, contact your maintenance engineer.
Error 
Reference
Name Remedial Action
Table 8-1: Faults and Warnings (Continued)