Maintenance
6545−1/A1
Winterthur Gas & Diesel Ltd.
3/ 6
10) Attach chain block 94017-028 (H3) with
shackle 94019H to the lug in the gallery
as shown in Fig. 3.
11) Attach chain block 94017-029 (H4) with
shackle 94019H to the next lug on the
gallery.
12) Attach trolley 94015F to the beam (2).
13) Attach chain block 94017-028 (H5) with
shackle 94019L to the trolley 94015F.
14) Attach the hook of chain block H3 to
the slings on the electric motor (1) and
take the weight over.
15) Use chain blocks (H3), (H4) and (H5) to
move the electric motor to the right as
shown in Fig. 3.
16) Roll the electric motor (1) with the
trolley 94015F towards driving end and
take over with engine room crane.
CAUTION
Damage Hazard: Do not
put the electric motor on
the floor without an
applicable support or
damage to the impeller can
occur.
17) Use the engine room crane to carefully
move the electric motor to an
applicable area.
Note: For data about the procedure to
clean the impeller and to replace
the ball bearing, see the
documentation of the auxiliary
blower manufacturer.
Auxiliary Blower: Maintenance
2015−08
Fig. 3
94017−028
94019H
94019L
2
1
94017−028
H3
H1
H5
94015F
H4
94019H
94017−029
WCH03041
To Next Page
Loading...
