Maintenance
5552−1/A2
Winterthur Gas & Diesel Ltd.
1/ 9
Camshaft and Bearing Shells − Removal and Installation
(Independent Lubrication System)
Tools:
2 Pre-tensioning jack 94557 1 Screwjack 94567B
3 Support 94566 1 Connection block 94934
1 Support 94566A 1 Pressure gauges 94934A
6 Roller lifting tool 94569B 3 HP hoses 94935
1 Assembly template 94567 1 Hydraulic unit 94942
1 Assembly template 94567A
1. Preparation 1.......................................................
2. Oil Baffle − Removal 3..............................................
3. Bearing Shells − Removal 4.........................................
4. Camshaft − Removal 5..............................................
5. Camshaft and Bearing Shells − Installation 5.........................
6. Oil Baffle − Installation 7............................................
7. Completion 9.......................................................
1. Preparation
Note: These procedures are applicable to a supply unit that has an independent
lubrication system.
1) Remove the covers (2, Fig. 1) from the casing (3).
2) Remove the fuel pumps (1) refer to 5556−1, or as an alternative lift the rollers (see
step 3) to step 4).
Fig. 1
WCH02962
1
2
3
Note: Some parts can look different.
2015
Supply Unit
To Next Page
Loading...
