Maintenance
9403−1/A1
Winterthur Gas & Diesel Ltd.
1/ 1
Explanation
1. General
The tools required for maintenance of the engine are divided into two groups:
1) Standard tools
2) Recommended special tools
When ordering additional tools or replacements, the tool No. as well as the tool
description including engine type must be indicated (see 9403−5).
Detailed instructions on the arrangement and application, overview, storing, servicing
and maintenance of the hydraulic pre-tensioning jacks are given in 9403−2 to 9403−4.
A separate set of tools is issued for certain components from sub-suppliers, which
should also be stored separately from the engine tools.
Note: Several tools require special screws and/or devices which must not be
lost. Therefore, tapped holes are bored additionally into these tools and
the mentioned screws and/or devices must always be kept at the proper
depositories ’DP’ when they are not used!
2. Standard tools
... are tools and devices required for normal maintenance work on the engine. In this
respect take into consideration that, depending on the design execution of the engine,
certain tools and devices which are mentioned in the above sheets are not required
for specific maintenance work, and are therefore not part of the engine tools supply.
3. Recommended special tools
... are tools and devices, which allow certain maintenance work to be done with more
ease, and in a shorter time, than with the standard tools.
These tools can be ordered separately either with the engine or at a later date.
4. Special tools available on loan
... are such tools and devices which are loaned for transportation and for erection of
the engine. They are to be returned to the engine manufacturer after completion of
engine erection.
Tools
2014
To Next Page
Loading...
