WinGD X92 - Removal and Installation (with Optional Tool); Removal Procedure

Maintenance
2138−1/A2
Winterthur Gas & Diesel Ltd.
1/ 4
Removal and Installation
Tools:
1 HP oil pump 94931 1
Connection nipple (G¼ inch)
94934I
1 Pressure gauge 0 bar to 20 bar 94934B 1 HP hose 94935
1. General
If it is not necessary to remove the cylinder liner (1, Fig. 1) you must not drain the
cylinder cooling water.
Steps 1) to 3) are only necessary if the cylinder liner (1) must be removed.
1) Remove the two holders (4).
2) Disconnect the 10 pipes (3).
3) Seal the pipes (4) with applicable seals to prevent contamination.
1
2
WCH02856
4
2
6
3
5
4
4
7
3
Fig. 1: Cylinder Liner and Lubricating Quills
2. Removal Procedure
1) Loosen the nuts (5) of the unions.
2) Remove the pipe (6) from the lubricating quill (2).
Note: Make sure that you do not damage the oil pipe (6).
3) Seal the oil pipe (6) with an applicable plug to prevent contamination.
4) Remove two the bolts (7).
5) Remove the lubricating quill (2).
6) If necessary, do a function check of the lubricating quills (see paragraph 3).
Lubricating Quill
2015