WinGD X92 - Installation

Maintenance
6708−1/A1
Winterthur Gas & Diesel Ltd.
5/ 8
13) Remove the manual ratchet (H4,
Fig. 11) from the rear of the water
separator (1).
Note: Do not remove the manual ratchet
(H4) from the holder (94667G).
14) Apply a light tension to the spur-geared
chain block (H2).
15) Loosen the spur−geared chain block
(H1). At the same time, tighten the
spur-geared chain block (H2) to move
the water separator under the engine
room crane.
16) Lower the water separator (1) to the
floor.
17) Remove the spur-geared chain blocks
(H1, H2) from the tool (94667) on the
water separator (1).
18) Attach the engine room crane to the
tool 94667 on the water separator.
19) Use the engine room crane to move the
water separator (1) to an applicable
area.
20) Remove the engine room crane from
the water separator.
21) Remove the tools (94667) from the
water separator.
3. Installation
3.1 Rear Water Separator
1) Attach the tools (94667) to the top and
front of the water separator (1).
2) Use the engine room crane and the
spur-geared chain blocks (H1, H2,
Fig. 12) to get the water separator in
position.
3) Connect the manual ratchet (H4) to the
tool (94667) on the water separator.
Note: When you do step 4), keep the
tension on the spur-geared chain
blocks (H1, H2) to hold the mass of
the water separator (1).
4) Operate the manual ratchet (H4) to
move the water separator (1) into the
receiver a small distance.
Fig. 11
Fig. 12
H1
H2
94667
WCH02967
1
94667
H4
H1
H2
94667
94667GH4946671
WCH02967
2015
Water Separators: Removal and Installation