Maintenance6708−1/A1
Winterthur Gas & Diesel Ltd.
4/ 8
4) Operate the manual ratchet (H3, Fig 9)
to pull the water separator (1)
sufficiently so that you can attach the
tool (94667).
5) Attach the tool (94667) to top of the
water separator (1).
6) Attach the spur−geared chain block
(H1) to the tool (94667).
7) Apply a light tension to the spur-geared
chain block (H1).
8) Operate the manual ratchet (H3,
Fig. 10) to pull the water separator (1)
from the receiver. At the same time,
operate the spur-geared chain block
(H1) to hold the mass of the water
separator.
9) Remove the manual ratchet (H3) and
the tool (94667H).
10) Remove the tool 94667 from the front
of the water separator.
11) Remove the holder (94667H) and
manual ratchet (H3).
12) Attach the spur-geared chain block
(H2) to the tool (94667) on top the
water separator.
20152015
Fig. 9
Fig. 10
WCH02967
1
H3
94667
H2
H1
2
94667H
1
H3
94667
WCH02967
H1
H2
Water Separators: Removal and Installation
To Next Page
Loading...
