Maintenance
2138−1/A2
Winterthur Gas & Diesel Ltd.
3/ 4
4. Installation
CAUTION
Damage Hazard: The surfaces of the cylinder liner and the nozzle
tip make a metallic seal. The seat angles in the cylinder liner and
on the nozzle tip are different. Do not use a gasket between the
cylinder liner and the nozzle tip, or damage to the equipment can
occur.
Note: When you install the lubricating quill, replace all components.
1) Make sure that the sealing surfaces (SS, Fig. 3) are clean and have no damage.
SS
WCH02768
Fig. 3: Sealing Surfaces
2) Apply oil to the threads of the two screws (8, Fig. 4).
3) Put the lubricating quill (2) in position.
1
2
WCH02856
4
2
7
3
6
4
4
8
3
5
Fig. 4: Lubricating Quill − Installation
4) Torque the screws (8) to 10 Nm
5) Remove the plugs from the oil pipe (7).
6) Connect the oil pipe (7) to the lubricating quill (2).
2015
Lubricating Quill
To Next Page
Loading...
