Maintenance2138−1/A2
Winterthur Gas & Diesel Ltd.
4/ 4
7) Tighten the nuts (6, Fig. 4) of the screw-in union and angle union.
8) Step a) to step c) is only necessary if the cylinder liner was installed.
a) Remove the protection from the 10 pipes (3).
b) Connect the 10 pipes (3).
c) Attach the two holders (4) to the 10 pipes (3).
9) Bleed the oil pipes (7), refer to 7218−1, paragraph 3.2.
10) If necessary, bleed the cylinder lubricating pump (5), refer to 7218−1, paragraph 3.1.
11) Do a function check of the cylinder lubricating system, refer to 7218−1,
paragraph 1.2.
2015
Lubricating Quill
To Next Page
Loading...
