WinGD X92 - Page 177

Maintenance
2303−1/A1
Winterthur Gas & Diesel Ltd.
1/ 10
Remove, Disassemble, Measure Worn Parts, Assemble,
Install
Tools:
2 Distance holders 94230 1 Distance piece (11 mm) 94231C
1 Clamp ring (2-parts) 94231A 1 Distance piece (9 mm) 94231D
1 Distance piece (12 mm) 94231B 2 Spring assembly tool 94233
1 Template 94231E 1 Piston supporting device 94350
1 Platform 94142 1 Platform 94234
1 Platform 94143
1. General 1..........................................................
2. Procedure One 1...................................................
2.1 Preparation 1.................................................
2.2 Remove 2....................................................
2.3 Disassemble 3................................................
2.4 Worn Parts − Measure 3.......................................
2.5 Assemble 5...................................................
2.6 Installation 7.................................................
3. Procedure Two 7...................................................
3.1 Removal 7....................................................
3.2 Installation 10.................................................
1. General
There are two procedures to remove the piston rod gland:
D Procedure One: The piston and the piston rod gland is removed from the engine.
The piston rod gland is disassembled in an external piston support device 94350.
For more data, see paragraph 2.
D Procedure Two: The piston and the piston rod gland stays in the engine. The
piston rod gland is disassembled in the crankcase. For more data, see
paragraph 3.
Examine the piston rod gland for wear and damage on each overhaul of the piston
(see 0380-1). If necessary, replace the unserviceable parts.
When you assemble the piston rod gland, make sure that all parts are in a serviceable
condition.
2. Procedure One
2.1 Preparation
WARNING
Injury Hazard: Before you operate the turning gear, make sure
that no personnel are near the flywheel, or inside the engine.
1) Use the turning gear to turn the piston to BDC.
2) Remove the piston and the piston rod gland (1) (see 3403-1 Piston − Remove and
Install, paragraph 1 and paragraph 2).
2015
Piston Rod Gland