WinGD X92 - Installation

Maintenance3403−1/A1
Winterthur Gas & Diesel Ltd.
4/ 6
3. Installation
1) Put oil on the bore of the cylinder liner
(1, Fig. 8) and the surfaces of the
insertion funnel (94342).
2) Put the insertion funnel (94342) in
position on the cylinder liner (1).
3) Use the turning gear and turn the crank
to TDC.
4) Make sure that the items that follow are
clean:
D The piston rod gland
D The piston and the piston rings.
5) Make sure that the O-rings in the piston
rod gland are in a satisfactory
condition.
6) Put oil on the bore and the O-rings of
the piston rod gland.
7) Remove the cover plate 94345D from
the piston rod bore.
8) Install the piston suspension device
(94341, Fig.9) to the top of the
piston (1).
9) Make sure that the piston rod gland is
correctly installed on the piston rod.
10) Attach the two distance holders (94230,
Fig.2) to the piston rod foot (2) with the
four screws (3).
11) Lift the piston until the distance holders
(94230, Fig.4) touch the piston rod
gland.
12) Loosen the screws (3, Fig.9) and push
the supports (2) fully out.
13) Lift the piston (1) together with the
piston rod gland (4) from the device
(94350).
14) Turn the two hinged plates (5) up
before the piston rod foot touches
them.
15) Make sure that the bars (4, Fig.6) lock
the hinged plates (5) in the open
position.
2015
Piston: Removal and Installation
Fig. 8
1
94350
5
2
4
94341
Fig. 9
3
94342
WCH02943
1
WCH02943