Maintenance
3326−1/A1
Winterthur Gas & Diesel Ltd.
13/ 13
Note: During the step below, make sure
that the elastic bolts in the
connecting rod align with the
holes in the crosshead pin.
37) Carefully lower the crosshead pin (2,
Fig. 30) on to the connecting rod.
38) Use an applicable tool and sufficient
personnel to remove the two lifting
tools (94337).
39) Remove all manual ratchets, eye bolts
and spur gear chain blocks.
40) Remove the protection from the
crosshead pin (2).
CAUTION
Damage Hazard: Damage
will occur to an incorrectly
connected toggle lever.
Make sure that you
connect the toggle lever
correctly.
41) Connect the toggle lever (1) to the
crosshead pin (2). make sure that the
toggle lever is in the position shown.
6. Clearance Checks
1) Do the clearance checks, refer to 0330−1 Crosshead pin.
7. Completion
1) Install the round nuts to the elastic studs on the connecting rod, refer to 9403−4.
2) Install the top bearing cover, refer to 3303−5.
3) Disengage the turning gear.
4) Set the lubricating oil pump to on.
5) Make sure that the crosshead and the bottom end bearings of the connecting rod
have sufficient lubrication.
2015
Crosshead Pin − Removal / Installation / Clearance Checks
1
2
WCH02438
NOTE: THE
CRANK IS AT BDC
Fig. 30
To Next Page
Loading...
