Maintenance
2303−1/A1
Winterthur Gas & Diesel Ltd.
7/ 10
2.6 Installation
When you assemble the piston rod gland, make sure that all parts are in a serviceable
condition.
To install the piston rod gland, do the steps that follow:
1) Apply lubricating oil to the opening in
the cylinder jacket (3) and to the area
of the O-rings (4) on the housing (1,
Fig. 8).
2) Install the piston with the piston rod
gland, refer to 3403−1 (Installation of
the Piston, paragraph 3).
3) Make sure that the distance holders
(94230) are attached to the piston rod.
4) Make sure that the support (5) is
installed onto the cylinder jacket (3). If
necessary, torque the outer bolts (6) to
150 Nm.
5) Remove all tools and equipment from
the area.
3. Procedure Two
3.1 Removal
WARNING
Injury Hazard: You must prevent unwanted movement of the
crankshaft when you do the maintenance.
WARNING
Injury Hazard: Before you operate the turning gear, make sure
that no personnel are near the flywheel, or in the engine.
CAUTION
Damage Hazard: Do not get on the support 94344. The maximum
permitted weight is 120 kg.
1) Use the turning gear to turn the piston to BDC.
2) Install the platforms (94142 and 94143, Fig. 9).
2015
Remove, Disassemble, Measure Worn Parts, Assemble, Install
Fig. 8
WCH02292
3
4
1
2
5
6
To Next Page
Loading...
