Maintenance5552−1/A1
Winterthur Gas & Diesel Ltd.
6/ 6
5. Completion
1) Refer to 0330−1 Clearance Table, Group 5552 for the axial clearances.
2) If the axial clearances are not in the specified range, loosen the round nuts on one of
the bearing covers (see paragraph 2, step 2).
3) Put the bearing cover in position again, see paragraph 4, step 17) ,step 18), step 19)
and step 22) to step 25).
4) Attach the filling piece (1, Fig. 3) to the bearing cover with the two Allen screws (2).
5) If the fuel pumps (1, Fig. 6) were not removed, do step a). If the fuel pumps were
removed, do step b).
a) Remove the roller lifting tools (94569B).
b) Install the fuel pumps. See 5556−1.
6) Apply sealing compound to the sealing surfaces of the covers (2).
7) Install the covers (2) to the casing (3).
8) Set to on the oil pump.
9) Use the turning gear to turn the engine.
10) Make sure that lubricating oil flows to all lubricating points and bearings.
Fig. 6
WCH02962
1
2
3
2015
Camshaft and Bearing Shells − Removal and Installation
To Next Page
Loading...
