Selecting a location for the printer
• Leave enough room to open trays, covers, and doors and to install hardware options.
• Set up the printer near an electrical outlet.
WWaarrnniinngg:: To avoid the risk of fire or electrical shock, connect the power cord to an appropriately
rated and properly grounded electrical outlet that is near the product and easily accessible.
CCAAUUTTIIOONN——SSHHOOCCKK HHAAZZAARRDD:: To avoid the risk of electrical shock, do not place or use this
product near water or wet locations.
• Make sure that airflow in the room meets the latest revision of the ASHRAE 62 standard or the CEN Technical
Committee 156 standard.
• Provide a flat, sturdy, and stable surface.
• Keep the printer:
– Clean, dry, and free of dust
– Away from stray staples and paper clips
– Away from the direct airflow of air conditioners, heaters, or ventilators
– Free from direct sunlight and humidity extremes
• Observe the temperature range.
Operating temperature 10 to 32.2°C (50 to 90°F)
• Allow the following recommended amount of space around the printer for proper ventilation:
1. Top: 305 mm (12 in.)
2. Rear: 102 mm (4 in.)
3. Right side: 76 mm (3 in.)
4. Front: 508 mm (20 in.)
The minimum space needed in front of the
machine is 76 mm (3 in.).
5. Left side: 76 mm (3 in.)
36
Xerox
®
C315 Color Multifunction Printer User Guide
Set up, Install, and Configure
To Next Page
Loading...
