Setting up the printer to fax
• The following connection methods are applicable only in some countries or regions.
• During the initial printer setup, clear the fax function check box and any other function you plan to set up later,
then select CCoonnttiinnuuee.
• If the fax function is enabled and not fully set up, then the indicator light may blink red.
WWaarrnniinngg:: Do not touch cables or the printer in the area shown while actively sending or receiving a fax.
SETTING UP THE FAX FUNCTION
1. From the control panel, navigate to:
SSeettttiinnggss >> DDeevviiccee >> PPrreeffeerreenncceess >> RRuunn IInniittiiaall SSeettuupp
2. Turn off the printer, wait for about 10 seconds, then turn on the printer.
3. From the Before You Begin screen, select CChhaannggee tthhee SSeettttiinnggss aanndd CCoonnttiinnuuee wwiitthh tthhee WWiizzaarrdd.
4. From the Fax/Email Server Setup screen, enter the needed information.
5. Finish the setup.
Using the fax setup wizard in the printer
• This wizard appears only when analog fax is not yet set up.
• This wizard only sets up the analog fax. To setup other fax modes, go to Settings > Fax > Fax Setup.
• Before using the wizard, make sure that the printer firmware is updated. For more information, see Updating
Software.
1. From the home screen, touch FFaaxx.
2. Touch SSeett uupp nnooww.
3. Type the fax name, and then touch NNeexxtt.
4. Enter the fax number and then touch DDoonnee.
46
Xerox
®
C315 Color Multifunction Printer User Guide
Set up, Install, and Configure
To Next Page
Loading...
